Sharp LC-20B5M Flat Panel Television User Manual


 
31
Rec Mode
Use this setting for recording images you are currently
watching. Select the recording mode (picture quality) for a
motion picture.
Press MENU to display the Menu screen.
Press \/| to select “Card”.
Press '/" to select “Video setup”, and press OK.
Menu
[
Card Video setup
]
Select mode
Video setup
Timer Rec.
Still setup
Format
Card
Press '/" to select “Rec mode”, and press OK.
:
SELECT
OK:
ENTER
M :
BACK
E :
EXIT
Menu[Card V
Menu[Card V
ideo setup]
Rec mode
Pre-recording
Repeat Selected desired item
Slowmotion
Zoom SP
Edit
LP
EP
Press '/" to select “SP”, “LP” or “EP”, and press OK.
Press MENU to exit.
NOTE
When using the SP mode, differences in picture quality can occur
depending on the card used. In this case, it is recommended to
record in the LP mode.
When switching to the Card mode after finishing the recording, the
motion picture mode is indicated.
When switching to the Card mode after finishing recording a still
picture, the still image mode is indicated.
Pre-Recording
When setting pre-recording to “On”, recording will be initiated
starting from 5 seconds earlier.
Press MENU to display the Menu screen.
Press \/| to select “Card”.
Press '/" to select “Video setup”, and press OK.
Menu
[
Card Video setup
]
Select mode
Video setup
Timer Rec.
Still setup
Format
Card
Press '/" to select “Pre-recording”, and press OK.
:
SELECT
OK:
ENTER
M :
BACK
E :
EXIT
Menu[Card VMenu[Card Video setup]
Rec mode
Pre-recording
Repeat Selected desired item
Slowmotion
Zoom
Edit
O n Off
Press \/| to select “On”, and press OK.
Press MENU to exit.
NOTE
Pre-recording is enabled only in the motion picture mode. It is not
possible to capture an image a few seconds before as a still
picture.
When recording with the “Pre-recording” mode set to “On”
The LAP time at playback will be a few seconds longer than the
LAP time at the end of recording.
Depending on the timing the recording was started, the time the
pre-recording can return may vary slightly, for example, immedi-
ately after selecting a channel or immediately after turning on the
power.
When timer recording has been set in “Timer Rec.”, the start time
will not return even if “Pre-recording” is set to “On”.
Recording on a Memory Card (Video Setup)
1
2
3
4
5
6
1
2
3
4
5
6
Selected item
SP
LP
EP
Description
Use this mode for normal use.
Use this mode for making long recordings.
When recording with the LP/EP mode, there is a
bigger difference in the image and sound quality
than recording in the SP mode.
LC-15_20B5M_E_P29-32.p65 04.1.30, 11:41 AM31