Sharp LC32LE450U Flat Panel Television User Manual


 
Watching TV Watching TV
A
CH
+
VOL
MENU
INPUT
POWER
ii .....
O PowER
Press POWER on the TV, or POWER on the remote control
unit to turn the power on.
POWER indicator: Power on, Green; Power off, red.
Press POWER on the TV, or POWER on the remote control
unit again to turn the power off.
The TV enters standby and the image on the screen
disappears.
If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the AC outlet.
Small amount of electric power is still consumed even when
the TV is turned off.
If there is no signal input for 15 minutes, the power will turn
to standby mode automatically.
4.Air/Cable (Antenna setting)
Make surewhat kind of connection is made
with your TVwhen selecting "Air" or "Cable".
Press / to select "Air" or "Cable" and
press ENTER or I_ to the next step.
During channel searching
Wait until the channel scan to complete.
Ifyou press EXIT, TV willexit EZSetup.
Ifyou skip this step, the channel search can be
performed inthe Setup Menu. (Seepage 31.)
6. Completed
After setting complete, the screen will show "Status:
Scan Complete", press ENTER or I_ to finish the
EZ Setup.The TV will then switch to the first channe
found.
When you turn on the TV for the first time, the EZ
Setup will guide you through the setup process.
Perform the following steps before you press
POWER on the remote control unit.
1. Insert the batteries into the remote control
unit. (See page 11.)
2. Connect the antenna cable to the TV. (See
page 10.)
3. Plug in the AC cord to the AC outlet. (See
page 8.)
1. Language Setting
Select the OSD menu language from English,
Spanish, or French.
Press / to select the desired language
listed on the screen, and then press ENTER or
I_ to the next step.
2. TV Location Setting
Select "Home" or "Store" for the location where
you plan to install the TV. This product qualifes for
ENERGY STAR in Home mode default setting.
Press / to select "Home" or "Store"
and press ENTER or I_ to the next step.
5. Start Channel Scan
Channel auto search makes the TV look for all
channels viewable in the set area.
When "Air" or "Cable" is selected in Tuner setting,
press / to select "Scan", and then press
ENTER or I_ to start auto seach.
Auto programming may take 20+ minutes to
complete. Please wait until you see the Auto
programming complete message.
3. Time Zone Setting
Press •/T to select the current local time zone.
Press ENTER or I_ to continue to the next
screen.
Q- 20 Q- 21