Filter
Top Products
E-17
Operation
2
4
5
2, 6
3
Basic Operations
When the power is on, the LAMP REPLACEMENT indicator
lights indicating the status of the lamp.
Green: Lamp is ready.
Flashing green: Warming up.
Red: Change the lamp.
Press INPUT to select the desired input mode.
Press INPUT again to change the mode.
EXAMPLE
INPUT 1 Mode INPUT 2 Mode INPUT 3 (VIDEO) Mode
3
• When no signal is being received, “NO SIGNAL” will be displayed. When a signal that the projector is not
preset to receive is being received, “NOT REG.” will be displayed.
Press VOLUME / to adjust the volume.
Press MUTE to temporarily turn off the sound.
Press MUTE again to turn the sound back on.
Press POWER OFF.
Press POWER OFF again while the message is displayed.
• If you accidentally pressed POWER OFF and do not want to turn off the power, wait until the power off
screen disappears.
• When POWER OFF is pressed twice, the POWER indicator will light up red and the cooling fan will run for
about 90 seconds. The projector will then enter standby mode.
• Wait until the cooling fan stops before disconnecting the power cord.
• The power can be turned on again by pressing POWER ON. When the power is turned on, the POWER
indicator and the LAMP REPLACEMENT indicator light green.
• The POWER indicator flashes if the bottom filter cover is not securely installed.
6
5
4
Press Power ON.
• The flashing green LAMP REPLACEMENT
indicator shows that the lamp is warming up.
Wait until the indicator stops flashing before
operating the projector.
• If the power is turned off and then immediately
turned on again, it may take a short while before
the lamp turns on.
• If the keylock level is set to “Level A” or “Level
B”, Power ON and Power OFF can only be used
on the remote control. (See page 41.)
• After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the
exhaust vent. This odor will soon disappear with use.