Filter
Top Products
E-56
Appendix
Specifications
Product type
Model
Video system
Display method
LCD panel
Lens
Projection lamp
Contrast ratio
Video input signal
S-video input signal
Component input signal
Horizontal resolution
Audio output
Computer RGB input signal
Pixel clock
Vertical frequency
Horizontal frequency
Computer control signal
Speaker system
Rated voltage
Input current
Rated frequency
Power consumption
Operating temperature
Storage temperature
Cabinet
I/R carrier frequency
Laser pointer of remote control
Dimensions (approx.)
Weight (approx.)
Supplied accessories
Replacement parts
LCD Projector
XG-P10XU
PAL/SECAM/NTSC 3.58/NTSC 4.43/DTV 480P/DTV 720P/DTV 1080I
LCD panel ן 3, RGB optical shutter method
Panel size: 1.3Љ (20.0 [H] ן 26.6 [W] mm)
Display method: Translucent TN liquid crystal panel
Drive method: TFT (Thin Film Transistor) Active Matrix panel
No. of dots: 786,432 dots (1,024 [H] ן 768 [V])
1–1.3ן zoom lens, F1.7–2.3, f ס 49.1–63.8 mm
200 W UHP lamp
250:1
RCA Connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Ω terminated
RCA Connector: AUDIO, 0.5 Vrms more than 22 kΩ (stereo)
4-pin Mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75 Ω terminated
C (chrominance signal): Burst 0.286 Vp-p, 75 Ω terminated
BNC Connector (INPUT 1)
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
P
B: 0.7 Vp-p, 75 Ω terminated
P
R: 0.7 Vp-p, 75 Ω terminated
520 TV lines (video input), 750 TV lines (DTV 720P input, Dot by Dot)
2 W ם 2 W (stereo)
15-PIN MINI D-SUB CONNECTOR (INPUT 1, 2), 5 BNC CONNECTOR (INPUT 1):
RGB separate/composite sync/sync on green type analog input: 0–0.7 Vp-p, positive,
75 Ω terminated
S
TEREO MINIJACK: AUDIO, 0.5 Vrms, more than 22 kΩ (stereo)
H
ORIZONTAL SYNC. SIGNAL: TTL level (positive/negative) or composite sync (Apple only)
V
ERTICAL SYNC. SIGNAL: Same as above
12–230 MHz
43–200 Hz
15–126 kHz
9-pin Mini DIN male connector (RS-232C Input Port)
1
31
⁄32Љ (5 cm) round ן 2
AC 110–120/220–240 V
3.2 A/1.6 A
50/60 Hz
300 W
41°F to 104°F (ם5°C to ם40°C)
מ4°F to 140°F (מ20°C to ם60°C)
Plastic
38 kHz
Wave length: 650 nm / Max. output: 1 mW / Class II Laser Product
10
9
⁄32Љ (W) ן 5
15
⁄32Љ (H) ן 14
1
⁄64Љ (D) (261 ן 139 ן 356 mm) (main body only)
10
9
⁄32Љ (W) ן 6
9
⁄64Љ (H) ן 16
13
⁄64Љ (D) (261 ן 156 ן 411.5 mm) (including
adjustment feet and projecting parts)
16.1 lbs. (7.3 kg)
Remote control, Two AA size batteries, Power cord (11Ј 10Љ, 3.6 m), Computer RGB cable
(9Ј 10Љ, 3 m), Computer audio cable (9Ј 10Љ, 3 m), Three BNC-RCA adaptors, PS/2 mouse
control cable (3Ј 3Љ, 1 m), USB mouse control cable (4Ј 11Љ, 1.5 m), DIN-D-sub RS-232C
cable (6
45
⁄64Љ, 15 cm), Remote mouse receiver, Extra air filter, Lens cap (attached), CD-
ROM, LCD projector operation manual, LCD projector quick reference, Sharp Advanced
Presentation Software operation manual
Standard lens unit (CLNS-0169CE02), Lamp unit (Lamp/cage module) (BQC-XGP10XU/1),
Remote control (RRMCG1585CESA), AA size batteries, Power cord (QACCU5013CEZZ),
Computer RGB cable (QCNW-5304CEZZ), Computer audio cable (QCNW-4870CEZZ),
BNC-RCA adaptors (QPLGJ0107GEZZ), PS/2 mouse control cable (QCNW-5113CEZZ),
USB mouse control cable (QCNW-5680CEZZ), DIN-D-sub RS-232C cable (QCNW-
5288CEZZ), Remote mouse receiver (RUNTK0673CEZZ), Air filter (PFILD0088CEZZ), Lens
cap (PCAPH1056CESA), CD-ROM (UDSKA0022CEN1), LCD projector operation manual
(TINS-7052CEZZ), LCD projector quick reference (TINS-7053CEZZ), Sharp Advanced
Presentation Software operation manual (TINS-7054CEZZ)
This unit has some inactive TFTs within acceptable tolerances which
may result in illuminated or inactive dots on the picture screen. This
will not affect the picture quality or the life expectancy of the unit.
If you have any questions about this matter, please call toll free 1-888-
GO-SHARP (1-888-467-4277). U.S.A. ONLY
This SHARP projector uses LCD (Liquid Crystal Display) panels. These
very sophisticated panels contain 786,432 pixels (ן RGB) TFTs (Thin
Film Transistors). As with any high technology electronic equipment
such as large screen TVs, video systems and video cameras, there
are certain acceptable tolerances that the equipment must conform
to.
Specifications are subject to change without notice.