Filter
Top Products
ENGLISH
61
CONNECTION SYSTEM WITH VARIOUS WAYS OF BEING USED (Continued)
IN
OUT
AV-IN1AV-IN1AV-IN3
IR
OUT
POWER
INPUT
DC12V
FACTORY
SERVICE
S-VIDEO
MONITOR
OUT
MONITOR
OUT
VIDEO
AUDIO
L
AUDIO
R
AV-IN2
/OUT
ANT.
Wireless Center
When connecting to amplifier
or stereo, etc.
To Videoinput terminal
(
Red
)
(
White
)
(
Yellow
)
(
Red
)
(
White
)
(
Yellow
)
Audio/Video cord
(commercially available)
To AV-IN2/OUT terminal
To audio input terminal
Monitor Output for Picture and Sound Output from AV-IN2/OUT Terminal
It is possible to output picture and sound being received by this unit from the AV-IN2/OUT terminal of the Wireless Center.
Note:
• Pictures and sound you have recorded cannot be used without permission from the copyright owner, other than for personal enjoyment.
• Transmission of pictures and sound from the Wireless Center to the main unit may take some time. For this reason, a picture that is slightly
delayed from the actual picture is displayed on the main unit. When recording pictures and sound on DVD or video while watching the main
unit, it will take about one second from pressing the picture record button on the remote control until actual picture recording starts.
• When recording pictures or watching pictures on another device via the AV-IN2/OUT terminal of the Wireless Center, “AV2-IN/OUT” is set
to “OUT ”.
If the television power supply is switched “off” using the remote control when the “AV2-IN/OUT” is set to “OUT ”, the power supply of the
Wireless Center is also put into a standby state, but output from the AV-IN2/OUT terminal continues as is. Therefore, if the main power
supply of the Wireless Center is switched off, output from the AV-IN2/OUT terminal stops.
* In the following cases, the power supply is in a standby state, but output from the AV-IN2/OUT terminal is possible.
• When television main power is “off”.
• When the power supply button of the remote control is “off”.
• Also in cases when communication is not possible due to some fault, output from the AV-IN2/OUT terminal is interrupted. For the purpose
of power conservation, when output from the AV-IN2/OUT terminal is not being used, it is recommended that the main power of the
Wireless Center be turned off.
* Even if the main power of the Wireless Center is turned off, the antenna output and video 1 are output.