Filter
Top Products
E-16
Connecting to the Computer RGB Input (RGB 1, 2)/Output Terminals
You can connect your projector to a computer for easy projection of full-color computer images, and an external
monitor for simultaneous viewing.
1. Connecting to an IBM-PC (VGA, SVGA,
XGA) or a Macintosh Series computer
Plug one end of the RGB signal cable into the RGB
INPUT terminal on the projector and the other end
into the RGB signal output terminal on the
computer, and secure the plugs by tightening the
thumb screws.
Notes:
• This connection is possible only when using a computer with a VGA/
SVGA/XGA or Mac display output port.
• By using RGB INPUT 2 and PC CONTROL 2, another computer can
be connected to and operated with the projector.
• For use with some Macintosh computers, a Macintosh/VGA adaptor
may be required. Contact your nearest Authorized Sharp Industrial
LCD Product Dealer or third-party manufacturer.
COMPUTER RGB
IN 1 IN 2
ANALOG RGB OUT
1
IBM-PC (VGA,
SVGA, XGA)
Series (computer)
RGB Signal
Output Socket
Rear view of the projector
RGB Signal
Input Socket
RGB Signal
Cable
(Supplied)
3
COMPUTER AUDIO
PC CONTROL
12
AUDIO
OUTPUT
IN 2
WIRED
REMOTE
IN 1 IN 2
3. Connecting to the COMPUTER AUDIO
INPUT
• The COMPUTER AUDIO INPUT 1 accepts audio from
the COMPUTER RGB 1 input, and the COMPUTER
AUDIO INPUT 2 accepts audio from the COMPUTER
RGB 2 input.
• Connect a 3.5 mm Stereo Minijack cable from the
audio output terminal on the computer to the
COMPUTER AUDIO INPUT terminal on the projector.
2. Connecting to other compatible
computers
When connecting the projector to a compatible computer
other than an IBM-PC (VGA/SVGA/XGA) or Macintosh
series, a separate cable may be needed. Please contact
your dealer for ordering information.
Notes:
• Connecting computers other than the recommended types may
result in damage to the projector, the computer, or both.
• Connect the audio from the computer to the COMPUTER AUDIO
INPUT terminal.