Filter
Top Products
18
SYSTEM SETUP
• The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most situations,
you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be changed later.
1. Turn the setup menu on.
• “SOUND PRMT” will be shown.
• To turn the menu off, press this button again.
• When the RETURN is pressed on a sub-menu, it will
returns to the previous menu.
2. Select the desired menu using the CURSOR UP/DOWN buttons.
• Each time these buttons are pressed, the setup menu
is selected as follows :
→ “SOUND PRMT” ↔ “TONE” ↔ “SPK SET” ←
(
Sound Parameter) (Speaker Setup)
• When “TONE” is selected, see “Setting the Tone” on
page 23.
3. When selecting the “SOUND PRMT” or the “SPK SET”, press the OK button to enter it’s setup menu.
• When “SPK SET” is selected, see “Setting the speaker
setup” on page 20.
• When “SOUND PRMT” is selected, see “Setting the
sound parameter” below.
• You can adjust the different sound parameters for optimum surround effect.
Setting the sound parameter
SOUND PRMT
L.SYNC 0 / 0 ~ 9.0
D.M. CH1 / CH2 / CH1+2
DRC OFF / MID / MAX
LFE 0 dB / -10 / OFF
C.WIDTH 3 / 0 ~ 7
DIMEN 0 / -3 ~ +3
PNRM OFF / ON
ENGLISH
1. Press the CURSOR UP/DOWN buttons to select the desired parameter.
■Notes :
• “C.WIDTH”, “DIMEN” and “PNRM” can be selected only while listening in Dolby Pro Logic II Music or Dolby Pro Logic IIx
Music mode.
• “D.M.” and “DRC” settings are not valid when BD/DVD is selected as an input source.
VR-654(G)_ENG_100129_VR-654(G) 2010-01-29 오전 10:45 페이지 18