Filter
Top Products
ENGLISH
51
[BD PLAYER SECTION]
PROBLEM POSSIBLE CAUSE REMEDY
N
o playback
Malfunction
No picture
Noisy or distorted picture
Abnormal picture or no
picture
Slight pause of picture
Noisy or distorted sound
BD-LIVE contents
cannot be loaded
•
The disc is loaded upside down.
• The disc is not playable.
• The disc is dirty.
• The recorded disc is not correctly finalized.
• The parental level is not set correctly.
• The symbol about invalid operation is displayed.
• The disc is scratched, dirty badly or unplayable.
• The video cords are disconnected.
• The incorrect selection of input source on the TV.
• The disc is not playable.
• The unit is connected to a VCR directly and the
copyguard function is activated.
• The disc is dirty.
•
It is in rapid advance or reverse playback, or in frame
a
dvance playback.
• The resolution is not set correctly for video signals to
be output form the COMPONENT and the HDMI
OUTs.
• The TV does not support HDCP.
• The TV type of this unit is different from that of your
TV or the disc.
• The layer transition occurs during playback of DVD
Videos, etc. recoded in dual-layer format.
• The disc is dirty.
• Poor connections between this unit and broadband
router and/or modem.
• The USB memory device is disconnected.
• The BD-Live Internet Access is set to “Prohibit
Access”.
• The BD disc does not support BD-LIVE.
• The network settings are not set correctly.
•
Reload the disc with the printed side up.
•
Use a playable disc.
•
Clean the disc.
• Load a disc that is correctly finalized.
• Set the parental level setting correctly.
(Refer to “SETTING THE PARENTAL CONTROL”
on page 44.)
•
Adjust the setting correctly.
(
Refer to “SYMBOL ABOUT INVALID OPERATION”
on page 25.)
• Press the POWER ON/STANDBY button to turn the
power off, press this button again and then unload the
disc.
•
Connect the cords correctly.
• Select the input source correctly.
• Use a playable disc.
• Connect the unit so that the picture signal is
transferred directly to the TV.
• Clean the disc.
• Sometimes small amount of picture distortion may
appear. This is not malfunction.
• Set the resolution correctly. (Refer to “SETTING THE
DISPLAY” on page 42.)
• This unit will not transfer the video signals via HDMI
connector to TV that does not support HDCP.
This is not malfunction.
• Set the TV type correctly. (Refer to “SETTING THE
DISPLAY” on page 42.)
• Sometimes slight pause may occur.
This is not malfunction.
• Clean the disc.
• Check the connections and connect all cords securely.
• Connect the USB memory device to this unit.
• Set it to “Always Allow Access” (Refer to “SETTING
THE SYSTEM” on page 41.)
• Load a disc that supports BD-LIVE.
• Set the network settings correctly. (Refer to “SETTING
THE NETWORK” on page 45.)
VR-654(G)_ENG_100129_VR-654(G) 2010-01-29 오전 10:45 페이지 51