Filter
Top Products
5. Press the down arrow button (6) repeatedly until the desired
TIMER appears in the LCD display (2).
6. Press the right arrow button (6). CONFIRM CLEAR appears
in the LCD display (2).
7. Press the right arrow button (6). First SUCCESS then
CODE SETUP appears in the LCD display (2).
8. Press the
EXIT button (8) repeatedly until the standard
display appears in the LCD display (2).
Note:
If no button is pressed for approx. 30 seconds, the message
"TIMEOUT" appears in the LCD display (2). Then the standard
display is shown automatically.
LEARN-SETUP – Learning functions
The universal remote control can learn the button signals of
an original remote control. Take note of the following points:
• The learning function can learn a maximum of 150
button signals.
• Use new batteries for the universal remote control and the
original remote control.
• Maintain a distance of at least one metre to other light
sources. The light sources could disrupt the infrared trans-
mission.
• You can extend the configured device codes using the l
earning function.
• Place the universal remote control and the original remote
control on a flat surface at a distance between 15 and
50 mm. See the graphic "Remote control spacing".
Remote control spacing
The "LEARN SETUP“ menu offers the following functions:
MODE LEARN – Learn buttons for a device.
MODE CLEAR – Clear learned buttons for a device.
ALL LEARN CLEAR – Clear learned buttons for all devices.
24
IB_KH2150_JOE23594_LB3bcI.qxd 05.08.2008 16:52 Uhr Seite 24