Filter
Top Products
SUR-25 User Manual
Ch.
SUR-25 User Manual
Ch.
Page
16
Chapter 3 – Setting Up the SUR-25
Before the SUR-25 can be used to control a device, it
needs to be configured to display your existing remote control
buttons and also programmed to send the correct infrared
signals. This chapter guides you through the Touch Screen
layout and SUR-25 setup procedure.
To get started, you will first set the date and time. Then you
can proceed to create devices and program the SUR-25.
Setting UpSetting Up
Setting UpSetting Up
Setting Up
33
33
3
Date and ClockDate and Clock
Date and ClockDate and Clock
Date and Clock
To use the Date selection in the
SETUP Menu:
1. Press and hold the SETUP
button on the Touch Screen for 3
sec. Press each number button (2, 4,
6, 8) until it disappears.
2. Use the arrow buttons on the
Touch Screen to select DATE
(displayed in the upper right
corner) and then press the OK
button.
Enter the year, month and date first.
3. Use the LEFT and RIGHT arrow
keys to move the curser and the UP
and DOWN arrows to change the
selection. Press OK when finished.
Now set the hour, and minutes.
4. Use the arrow keys as in Step 3.
5. Press OK when finished and then
EXIT to leave the SETUP menu.
1
3
%
5
Page
45
4. Use the arrow keys to select
the time.
5. Press OK
Note: If you used SPEC (Specific
Day/Time) you will also have to set
the date.
6. Select the key that the timer will
press. If you want, you can switch
devices (use device keys) or Touch
Screen pages. (Use the
button.)
At the selected time and date, the
SUR-25 will send the infrared code
or start the macro associated with
the key selected in step 6. When
finished press the EXIT key to leave
the MACRO Menu.
Macro TimersMacro Timers
Macro TimersMacro Timers
Macro Timers
66
66
6
2