Sony BDP-S190 Blu-ray Player User Manual


 
2
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
The AC power cord (mains lead) must be changed
only at a qualified service shop.
Batteries or batteries installed apparatus shall not
be exposed to excessive heat such as sunshine,
fire or the like.
CAUTION
The use of optical instruments with this product
will increase eye hazard. As the laser beam used
in this Blu-ray Disc/DVD player is harmful to
eyes, do not attempt to disassemble the cabinet.
Refer servicing to qualified personnel only.
This label is located on the laser protective
housing inside the enclosure.
Precautions
This unit operates on 110V - 240 V AC,
50/60 Hz. Check that the unit’s operating
voltage is identical with your local power
supply.
To prevent fire or shock hazard, do not place
objects filled with liquids, such as vases, on the
apparatus.
Install this unit so that the AC power cord
(mains lead) can be unplugged from the wall
socket immediately in the event of trouble.
Precautions
This equipment has been tested and found to
comply with the limits set out in the EMC
Directive using a connection cable shorter
than 3 metres.
On placement
Place the player in a location with adequate
ventilation to prevent heat build-up in the
player.
Do not place the player on a soft surface
such as a rug that might block the ventilation
holes.
Do not install this player in a confined space,
such as a bookshelf or similar unit.
Do not place the player in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust, or mechanical
shock.
Do not place the player outdoors, in
vehicles, on ships, or on other vessels.
If the player is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lenses inside the player. Should this occur,
the player may not operate properly. In this
case, remove the disc and leave the player
turned on for about half an hour until the
moisture evaporates.
Do not install the player in an inclined
position. It is designed to be operated in a
horizontal position only.
Do not place heavy or unstable objects on
the player.
Do not place any objects other than discs on
the disc tray. Doing so may cause damage to
the player or the object.
Take out any discs from the tray when you
move the player. If you don’t, the disc may
be damaged.
Disconnect the AC power cord (mains lead)
and all other cables from the player when
you move the player.