Filter
Top Products
Step 2: Setting up the remote commander (continued)
Setting the COMMAND MODE switch
To remotely control the VCR with the
remote commander, set COMMAND MODE
on the remote commander to the same
position as that on the VCR. Usually set
to VTR 3. Change the position as shown
below to control other Sony VCR's:
VTR 1
For Sony Betamax format VCR's
VTR 2
For Sony 8mm format VCR's
VTR 3
For Sony VHS format VCR's
To change the command mode position of
the VCR, press and hold COMMAND MODE
on the VCR for two seconds and repeat
until the desired position appears in the
display window.
Controlling other TV's with the remote commander
The remote commander is preprogrammed to control non-Sony TV's. If your TV is listed in the table below,
set the appropriate manufacturer's code number.
1
Set TV / RECEIVER / VIDEO at the top of the remote commander to TV /
RECEIVER.
2
Hold POWER down, and enter your TV's code number(s) using the
number buttons. Then release POWER.
Now you can use the POWER, VOL +/-, CH +/-, and TV / VIDEO buttons to
control your TV. You can also use the buttons marked with a dot to control
a Sony TV. To control the VCR, reset TV / RECEIVER / VIDEO to VIDEO.
Tip
If you set your TV's code number correctly while the TV is turned on, the TV turns
off automatically.
6
Getting Started
COMMAND
MODE
COMMAND MODE