Filter
Top Products
12
Getting Started
Notes
• You cannot enjoy a picture with an S video signal if your TV
does not conform to the S video signal. When your TV does
not have an S VIDEO input, connect the component via the
VIDEO INPUT connector using the video connecting cord (not
supplied) instead of the S video cord. For details, see page 9.
Refer to the instructions supplied with your TV.
• Refer to the instructions supplied with the component to be
connected.
• You cannot make digital audio recordings of discs recorded in
multi-channel surround format directly using an MD deck or
DAT deck.
• When you connect the component via the DIGITAL OUT
OPTICAL or COAXIAL connector, set Virtual Enhanced
Surround (VES) to “OFF.” Otherwise, the player will not output
signals from the DIGITAL OUT OPTICAL or COAXIAL
connector.
When you have made the connections using an optical or
coaxial digital connecting cord, do not set “DOLBY
DIGIT AL” to “DOLBY DIGIT AL,” “MPEG” to “MPEG” and
“DTS” to “ON.” If you do, a loud noise will suddenly come
out from the speakers, affecting your ears or causing the
speakers to be damaged.
Setups for the player
Some setup adjustments are necessary for the player
depending on the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 46.
• To listen to the sound through speakers connected
to a receiver (amplifier) which has a digital
connector and lacks a built-in DTS, Dolby Digital or
MPEG decoder, or to output the sound to a digital
component such as a DAT or MD deck
Set the “AUDIO SETUP” items in the setup display
(page 55) as shown in the illustration below. These are
the default settings.
Set “VES” to “OFF” in the Control Menu display (page
36). When you select the VES mode other than “OFF,”
the Virtual Enhanced Surround (VES) effect cannot be
heard.
Note
When you output the signals which do not reproduce the Dolby
Surround (Pro Logic) effect from the DIGITAL OUT OPTICAL or
COAXIAL connector, set “DOWNMIX” to “NORMAL” in
“AUDIO SETUP” in the setup display (page 56).
Receiver (Amplifier) Hookups
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
To set, press , then .
To quit, press .
OFF
STANDARD
DOLBY SURROUND
ON
ENTER
DOLBY DIGITAL:
MPEG:
D-PCM
PCM
DTS:
OFF
DISPLAY
Set the
items as
shown