Sony HKDV-501A DVD VCR Combo User Manual


 
4-5 PF1 Menu (Factory Settings)
4-56 Chapter 4 Menu Settings
Chapter 4 Menu Settings
4-5-3 Adjusting the Output Video
Signal (MASTER LEVEL to FINE)
Adjusting the output video signal
Follow the procedure below to adjust the output video
signal.
Adjusting the output video signal
1 Press the function button ([F4] to [F10]) whose
setting you wish to set.
The setting display section lights up.
2 Change the numerical value by pressing the G or
g button (or + or button).
To change the value quickly, press the buttons
while holding down the SFT button.
To set the preset value
Press the center cursor button.
prst appears over the respective function button.
3 Press the function button ([F4] to [F10]) after
adjusting the numerical value.
4-5-1 Selecting the Input Video
Signal (VIDEO IN)
Press the [F1] (VIDEO IN) button repeatedly to select
the video signal to input.
SDI: SDI video signal input to the HD SDI INPUT
connector
SDTI (Only if the optional HKDV-506A SDTI Board
is installed.): Dubbing signal (270 Mbps) input to
the SDTI (OPTION) IN connector.
Notes
The time codes to be recorded depend on the settings
of the TC menu.
4-5-2 Selecting the Reference
Signal (SERVO REF)
Press the [F2] (SERVO REF) button to select the
signal to be used as the reference signal for VTR
operations.
ext: The servo reference signal is forced to be EXT.
input: The signal from the HD SDI INPUT or SDTI
(OPTION) IN is used as the reference signal for
VTR operations. The [F1] (VIDEO IN) button
switches the video input signal.
auto: During recording or edit preset, the signal from
the HD SDI INPUT or SDTI (OPTION) IN is
used as a reference signal. In all other cases, the
servo operates using the signal setting of item
006.EXTERNAL REFERENCE select in the VTR
SETUP menu. If the signal selected in
006.EXTERNAL REFERENCE select is not
present, the servo operates using an internal
reference.
1,3
2
1,3