Filter
Top Products
A-8 Appendix
Appendix
ÅIN 00:00:00:00 ÅOUT 00:00:00:00
LOCK
DOLBY
NR
KEY-INH
PB/EE
CH.COND
GREEN
DIGITÅL
BÅSEBÅLL EDIT SET
HOME
TCR PLÅY 4FD F1
IN 00:00:00:00 OUT 00:00:00:00
01
Ó
04
µ
58
ß
00
ƒ
RECINH
off
ÅSSEM-
BLE
off
INS
TC
off
INS
VIDEO
off
INS
Å-CH1
off
INS
Å-CH2
off
INS
Å-CH3
off
INS
Å-CH4
off
INS
CUE
off
ERROR - 01
REEL TROUBLE-1
Error message
Error Messages and Warning Messages
Error Messages
When the unit ceases to opcº¡te correctly due to
malfunction or an internal system error, the alarm will
sound and an error message will be displayed on the
display.
Only one message will be displayed even when
multiple errors occur, but the error log menu keeps a
history of the errors.
For more information about error messages, refer to the
Maintenance Manual.
After the error occurs, eliminate the cause of the error
and turn the unit back on. If the error message appears
again when the unit is turned on, contact your Sony
representative.
For more information about eliminating errors, refer to the
supplied Maintenance Manual.
Protection Mode
To protect the tape and the mechanical parts of the
VTR, the servo control system automatically stops
tape transport and the drum motor and enters
protection mode when an error occurs.
Cassettes may not be inserted or ejected during
protection mode.
Note
When a cassette is stuck in the unit because of
protection mode, make sure to disconnect the power
before removing the cassette manually.
For information about removing cassettes manually, refer to
the supplied Maintenance Manual.
01 REEL TROUBLE-1: Slack in the tape was detected during threading or unthreading.
02 REEL TROUBLE-2: Slack in the tape was detected during searching, rewinding, or fast-forward.
03 REEL TROUBLE-3: Slack in the tape was detected during playback or recording.
04 REEL TROUBLE-4: Abnormality in tape speed was detected during fast-forward or rewinding.
05 REEL TROUBLE-5: Abnormality detected in the operation of S or T reels during cassette compartment operation. Or, current flow for S or
T reels deviated from the fixed value.
06 TAPE TENSION ERROR: Excessive tension detected during recording or playback.
07 CAPSTAN TROUBLE: Abnormality detected in capstan motor operation.
08 DRUM TROUBLE: Abnormality detected in drum motor operation.
09 TH/UNTH MOTOR TIME OUT: Abnormality detected during threading or unthreading.
0A THREADING TROUBLE: Tape top process did not end normally during threading.
10 DEW DETECTED: Condensation detected.
11 TAPE TOP/END SENSOR TROUBLE: Top and end of tape were detected simultaneously.
12 TAPE TOP SENSOR TROUBLE: Trouble with the tape top sensor.
13 TAPE END SENSOR TROUBLE: Trouble with the tap end sensor.
14 FAN MOTOR TROUBLE: Abnormality detected in the operation of the fan motor.
20 CASSETTE COMPARTMENT MOTOR LOCK: Abnormality detected during cassette compartment operation.
21 REEL SHIFT MOTOR LOCK: Abnormality detected when moving the reel base corresponding to the cassette size.
22 REEL POSITION SENSOR TROUBLE: Positions for L cassette and S cassette reel positions were detected simultaneously.
92 INTERNAL INTERFACE: Abnormality detected in the communication with the CPU on the circuit board.
93 CPU INITIALIZE ERROR: When the unit was powered up, an abnormality was detected in the initial communication with the CPU.
97 SV NV-RAM TROUBLE: An abnormality was detected while reading servo adjustment data after the unit was turned on.
A0 READ WRITE ERROR: Error occurred during reading and writing to the SS-88 on-board RAM.
A1 SY ROM ERROR: Error detected while reading system computer ROM data when the unit was turned on.