Filter
Top Products
Chapter 4 Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer
Chapter 4 Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer 59
Warning messages on duplication
If an error occurs during duplication, a STOP/
CAUTION number and warning message will be
displayed on LCD monitor and the video output screen.
The following table lists these warnings and messages.
If a warning message is displayed, check this table and
take the appropriate action.
Note
When a warning message other than above is displayed, consult your Sony dealer.
STOP/
CAUTION
No.
Warning Message
Cause/Remedy
00
RECORDER:
INPUT SELECT is not set to
HDV/DV.
INPUT SELECT switch on the recorder (the unit) is not set to HDV/DV.
t Set INPUT SELECT switch to HDV/DV.
01
i.LINK :
Cable not connected.
The i.LINK cable is not connected correctly.
t Connect the i.LINK cable correctly.
02
i.LINK :
Check i.LINK connection.
There are multiple i.LINK connections or the i.LINK connection is looped.
t You cannot connect multiple devices. Connect only one player to the unit.
03
i.LINK :
Check i.LINK connection.
The i.LINK cable has been unplugged and plugged in again.
t Check the i.LINK cable connection. Try to duplicate again.
10
PLAYER:
Recording.
The player is in the recording mode.
11
PLAYER:
No cassette
There is no cassette in the player.
12
PLAYER:
Cannot control.
The player cannot be controlled.
13
PLAYER:
Cannot control.
The player rejects control.
14
PLAYER:
Cannot control.
The player is disabled or is in a different mode than the recorder (the unit) has
requested.
15
PLAYER:
Cannot control.
The player is under an inappropriate condition.
16
PLAYER:
Cannot record due to
copyright protection.
A copyright protected signal is recorded on the cassette in the player.
t You cannot duplicate copyright protected signals.
17
PLAYER:
Error detected.
The player has detected self-diagnostics.
18
PLAYER:
Moisture
Moisture condensation has occurred in the player.
t Refer to the instruction manual of the player.
20
RECORDER:
No cassette inserted.
There is no cassette in the recorder.
21
RECORDER:
The tape is locked.
–check the tab.
REC/SAVE switch is set to SAVE switch on the cassette.
t Slide REC/SAVE switch to REC on the cassette.
22
RECORDER:
Reinsert the cassette.
The recorder (the unit) detected self-diagnostics.
t Insert a cassette again.
23
RECORDER:
Re-attach the power source
The recorder (the unit) detected self-diagnostics.
t Remove the power cord from the recorder.
24
RECORDER:
Condensation. Cannot open.
Try later.
Moisture condensation has occurred while the cassette is in the recorder (the
unit).
t Remove the cassette and power on and wait for more than one hour.
25
RECORDER:
Moisture condensation.
Turn off for 1H.
Moisture condensation has occurred while the cassette is not in the recorder.
t Power on the recorder and wait for more than one hour.
26
RECORDER:
Dirty video head.
Use a cleaning cassette.
The recorder’s (the unit) video heads are clogged.
t Clean the video heads with the supplied cleaning cassette
(see page 90)
.