Filter
Top Products
Chapter 5 Adjusting and Setting Through Menus
78 Chapter 5 Adjusting and Setting Through Menus
Icon/Menu Submenu Setting
OTHERS
PB YNR
PB CNR
BEEP
CLOCK SET
HOURS
METER
(page 92)
AC ON MODE
AUTO
STANDBY
Selects the noise reduction level for the luminance signals when a tape is played.
OFF : No noise reduction
LOW : Low noise reduction
HIGH : High noise reduction
Notes
• When you use noise reduction, there may be an afterimage depending on the condition of
the picture.
• Noise reduction is also available with pictures output from
HDV/DV jack. Use caution
when dubbing and editing a picture in HDV/DV.
Selects the noise reduction level for the chrominance signals when a tape is played.
OFF : No noise reduction
LOW : Low noise reduction
HIGH : High noise reduction
Notes
• When you use noise reduction, there may be an afterimage depending on the condition of
the picture.
• Noise reduction is also available with pictures output from
HDV/DV jack. Use caution
when dubbing and editing a picture in HDV/DV.
Selects whether or not the unit beeps.
ON : Enables the beep.
OFF : Disables the beep.
1 Press J/j buttons to adjust the number, then press K/k buttons to set the month,
day, hour, and minute.
2 Press EXEC button to execute.
Notes
• 12:00 AM stands for midnight and 12:00 stands for noon when [TIME DISPLAY] is set to
[12H].
• If you do not use the unit for 3 months or more, the built-in rechargeable battery will
become completely discharged, and the settings of the day and the time may be cleared
from the memory. In this case, charge the built-in rechargeable battery and set the clock
again
(page 92).
Displays the accumulated time counts (by the digital hours meter) in units of 10 hours or 10
counts.
OPERATION : Power on duration
DRUM RUN: Drum rotation duration
TAPE RUN: Tape run duration
THREADING: Tape unthreading count
Switches the state into which the unit goes when the unit is connected to the AC outlet.
STANDBY : Makes the unit go into the standby mode.
ON: Turns the unit on.
Selects whether the unit goes into the standby mode or not, if the unit has been in the stop
mode and no key operations have been attempted for more than one hour.
OFF : Leaves the unit in the stop mode.
ON: Makes the unit go into the standby mode.
Operating the Menus