Sony HVR-M25E VCR User Manual


 
Chapter 4 Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer
Chapter 4 Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer 57
Notes
• Before you start duplication, make sure that the
player has finished loading the cassette.
• The duplication starts after the i.LINK connection is
established so that the first part of the source tape is
dropped on the copied tape.
• If the player has functions such as auto repeat, set
them to OFF.
• If the player has a still timer function, set the still
timer to the longest time to ensure enough time for
rewinding the tape to the beginning.
• When you use a DSR-45 as the player, set REMOTE/
LOCAL switch of the DSR-45 to [LOCAL].
• If you operate the player while duplicating and the
PLAYER UNCONTROLLABLE warning message
appears and duplication stop, press EXEC button on
the unit to end duplication once and repeat the
procedures.
When [AUTO REW] in [DUPLICATE PLUS] is
set to [OFF]:
1 Connect the unit and the player using an i.LINK
cable (not supplied). After turning on power of the
unit and the player, set INPUT SELECT switch on
the unit to HDV/DV.
2 Locate the points where you want to start playback
and recording on each tape.
3 Press STOP button on the unit.
4 While holding DUPLICATE PLUS button down,
press PLAY button on the unit.
The unit enters the duplicate-standby mode. The
player enters the playback pause mode. Then
DUPLICATE PLUS and PLAY indicators on the
unit light and duplication starts.
To adjust the point where duplication starts, while
holding DUPLICATE PLUS button down, press
PAUSE button and PLAY button in step 4. The unit
will not start duplication until you press PAUSE
button again.
After confirming that the PLAYER display has
changed to [READY] (blinking) on LCD monitor,
adjust the duplication start point using the player, then
press PAUSE button on the unit to start duplication.
Notes
• Before you start duplication, make sure that the
player has finished loading the cassette.
• The duplication starts after the i.LINK connection is
established so that the first part of the source tape is
dropped on the copied tape. Play back the tape a few
frames back of the portion where you want to begin
the duplication.
• If the player has functions such as auto repeat, set
them to OFF. Also, when the player has an auto
rewind function, set the function to ON.
• You may not duplicate the beginning of the source
tape. Locate the recorded portion on the source tape,
and then start duplication.
• If there is a blank portion on the tape, the first part of
the recorded portion that follows may be dropped on
the copied tape.
• When the time code on a player operates either
discontinuously or incorrectly, the difference in frame
values between the numeric time codes may occur.
To cancel duplication
1 Press STOP button on the unit, and pause
duplicating.
While pausing, the following confirmation display
appears.
00:12:34:12
[ X ] : RESTART
Can adjust start
position or change
cassette.
[ x ] : END
DUPLICATE PLUS
2 Press j button.
Duplicating mode ends.