Filter
Top Products
20
SETUP SETUP SETUPSETUP SetupSETUP
KD-34XBR970
2-671-222-21(1)
Setting Up the Channel List
After you finish connecting the TV, you need to run the Initial Setup
feature, which automatically creates a list of available analog and
digital channels and lets you correct tilt and vertical correction
settings. The Initial Setup screens appear when you turn on your TV
for the first time after hooking it up.
Using Initial Setup To run Initial Setup
1 Press POWER to turn on the TV.
The Initial Setup screen appears.
Using the remote control, move the highlight to the desired
language, then press to select that language. The Tilt
Correction screen appears.
2 Press B b to correct any tilt of the picture. You can choose a
correction between +7 and -7. When finished, press .
3 The Vertical Correction screen appears. Press V v to make a
vertical correction to the picture. You can choose a correction
between +5 and -5. When finished, press .
4 The next screen instructs you to connect your cable/antenna.
Check that you’ve connected your signal source correctly.
To start Auto Program, highlight
Yes and then press .
Auto Program automatically creates a list of receivable analog
and digital channels. Auto Program may take 50 minutes or more
to complete. A progress bar is displayed while the channel list is
being created.
When Auto Program is finished, the lowest numbered channel is
displayed.
To run Auto Program again at a later time
❑
Use the Auto Program feature as described on page 40.
To add individual digital channels
❑
Use the Digital Channel feature as described on page 40.
To reset the TV to factory settings
1 Press POWER to turn on the TV.
2 Hold down RESET on the remote control.
3 Press TV POWER on the TV. (The TV will turn itself off, then back
on).
4 Release RESET.
For more details on using
Tilt Correction and Vertical
Correction, see pages 45-46.
z
To exit the Tilt Correction
and Vertical Correction screens,
press the MENU button.
z