Sony KDF-WF655 series Projection Television User Manual


 
7
KDF-WE/WF655
2-059-370-14 (2)
Antenna Grounding According to the NEC
Refer to section 54-300 of Canadian Electrical Code for
Antenna Grounding.
Lightning
For added protection for this television receiver during a
lightning storm, or when it is left unattended and unused
for long periods of time, unplug it from the wall outlet
and disconnect the antenna. This will prevent damage to
the receiver due to lightning and power-line surges.
Service
Damage Requiring Service
Do not attempt to service the set by yourself
since opening the cabinet may expose you to
dangerous voltage or other hazards.
Unplug the set from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:
When the power cord or
plug is damaged or frayed.
If liquid has been spilled into
the set.
If the set has been exposed
to rain or water.
If the set has been subject to
excessive shock by being
dropped, or the cabinet has
been damaged.
If the set does not operate
normally when following the
operating instructions.
Adjust only those controls
that are specified in the
operating instructions.
Improper adjustment of
other controls may result in damage and will often
require extensive work by a qualified technician to
restore the set to normal operation.
When the set exhibits a distinct change in
performance, it indicates a need for service.
Replacement Parts
When replacement parts are required, be sure the service
technician certifies in writing that he has used
replacement parts specified by the manufacturer that have
the same characteristics as the original parts.
Unauthorized substitutions may result in fire, electric
shock or other hazards.
Safety Check
Upon completion of any service or repairs
to the set, ask the service technician to
perform routine safety checks (as specified
by the manufacturer) to determine that the
set is in safe operating condition, and to so
certify. When the set reaches the end of its
useful life, ask a qualified service
technician to dispose of the set.
For Safety
Be careful when moving
the LCD projection TV
When you place the LCD projection
TV in position, be careful not to
drop it on your foot or fingers.
Watch your footing while installing the LCD projection
TV.
Carry the LCD projection TV in
the specified manner
If you carry the LCD projection TV in a
manner other than the specified manner
and without the specified number of
persons, it may drop and a serious injury
may be caused. Be sure to follow the instructions
mentioned below.
Carry the LCD projection TV with the specified
number of persons (see page 28).
Do not carry the LCD projection TV holding the
speaker grill.
Hold the LCD projection TV tightly when carrying
it.
Before carrying the LCD projection TV, disconnect
any accessories or cables.
Antenna lead-in wire
Ground clamps
Antenna lead-in wire
(NEC Section 810-20)
Grounding conductors
(NEC section 810-21)
Power service grounding
electrode system (NEC Art
250 Part H)
Ground clamp
Electrical
service
equipment
NEC: National
Electrical Code
01COV.book Page 7 Thursday, February 17, 2005 8:01 PM