Filter
Top Products
Using MENU Functions
37
GB
Selects the type of the video jack to be used from those on the left side of the TV.
Press M/m to select one of the following, then press .
Auto: Activates the component video jacks (Y, PB/CB, PR/CR), however, the composite video
jack is selected when the component video jacks are not connected.
Off: Activates the composite video jack ( ).
Corrects the image on your TV.
Auto (Factory setting): Automatically corrects double images.
Level 1-4: Aligns the images and improve the picture. The adjusted value tends to move
strongly away from Level 1, and towards Level 4.
Selects “High” when you use the TV at an altitude of 1,500 m or higher.
Select “Normal” to use the TV at normal altitudes.
Press M/m to select “High”, then press .
Selects this option after you replace the lamp.
When the lamp nears the end of its life, a message appears every time you switch on the TV.
Press </, arrow to select “Yes”, then Press .
Follow the on-screen procedure.
Notes
• Depending on environmental and other conditions, such as frequency of use, some lamps may burn
out before the lamp replacement message appears on the screen.
• Until you set the Lamp Replacement option, a message announcing that the lamp is at the end of its
life will appear every time you switch on the TV.
Provides an optimized display by automatically detecting the film content. Moving pictures
will appear clearer and more natural-looking.
Press M/m to select “Auto”, then press .
Tip
You can select this option for NTSC system pictures only.
Video2(Component)
Image Shift
Cooling Mode
Lamp Replacement
Cinema Drive
TV
Video
TV
Video
PC
Before adjusting After adjusting
TV
Video
PC
TV
Video
PC
TV
Video