Filter
Top Products
52
GB
When displaying the Twin
Picture, the quality of the sub
screen picture is not as good
as that of the main screen
picture
• The quality of the sub screen picture may be deteriorated depending on the
combination of the input signals.
A white oval image appears on
the screen
• This is due to strong light reflecting off both the TV screen and reflections
coming from behind the screens.
• Position your TV away from strong ambient light or sunlight, or lower any
ambient lights.
Sound
Problem Cause/Remedy
No sound, but good picture
• Press 2 +/– or % (Mute).
• Check that “Speaker” is set to “On” in the “Sound” menu (page 30).
Noisy sound
• See the “Picture noise (dotted lines or stripes)” cause/remedy on page 51.
Low sound volume
• “Mono” is selected. Set to “Auto” by pressing A/B (page 19).
• Check to see if the volume level is too low.
• Switch “Steady Sound” between “On” and “Off” in the “Sound” menu
(page 29).
No stereo broadcast signal is
received
• The stereo reception setting is inappropriate. Press A/B until “Auto” appears
on the screen (page 19).
Stereo broadcast sound
switches on and off, or is
distorted;
The sound switches between
stereo and monaural frequently
• The antenna connection is loose or the antenna cable is damaged. Check the
cable and connection on the TV, VCR, and on the wall (page 14).
• Adjust the antenna direction for the minimum interference. Contact a Sony
dealer for advice.
• Signal transmission is low. Try using a booster. Otherwise, use the fine
tuning (“Fine”) function (page 33).
• The broadcast signal has a transmission problem. Press A/B until a better
sound is heard (page 19).
No sound from the computer
• Check the connection of the audio cable (page 40).
General
Problem Cause/Remedy
The TV turns off automatically
(the TV enters standby mode)
• Check to see if the Sleep Timer function is activated (page 39).
• If the inside of TV becomes too warm, the TV automatically switches to
standby mode. Check to ensure the ventilation slots are not blocked or
clogged with dust.
Some input sources cannot be
selected
• Select “Video Label” in the “Setup” menu and cancel “Skip” of the input
source (page 36).
No picture but “PC” indication
appears when the TV is turned
on.
• The TV was set to the standby mode by the Power Management function
(page 36). Select a channel.
Problem Cause/Remedy