Filter
Top Products
14
Menu System
Colour Press / to decrease colour intensity.
Press / to increase colour intensity.
Colour cannot be adjusted for the RGB input.
Sharpness Press / to soften the picture.
Press / to sharpen the picture.
NR (Noise
Reduction)
Off/Low/Mid/High
Select to reduce the noise level of all connected equipment. It is
most effective on the signal from the VHF/UHF jack.
You cannot adjust NR (Noise Reduction) for equipment connected to the RGB
input.
Dynamic Pict On/Off
Select to enhance the picture contrast.
Colour Tone Cool/Normal/Warm/User1/User2/User3
Select to give bright colours a red tint (Setting is variable from Cool
to Warm).
Select User1, User2, or User3 to customise the Colour Tone by
adjusting Red Gain, Green Gain, and Blue Gain (tint), and store
them in memory.
Name Set: Select to name your personal settings. Press / /
/ to select the letter, then press OK. Finally press
/ / or to select the word “End” on the
screen and press OK to store.
• To correct the letter, select on the screen to go
back and press OK.
• For a blank, select on the screen and press OK.
Colour Correct On/Off
Select to emphasise reds and blues.
Colour Correct cannot be adjusted for the RGB input.
Gamma Correct High/Mid/Low
Select to adjust the balance between bright and dark areas of the
picture.
Reset Cancel/OK
Select OK to reset the picture to the factory preset levels.
Each option cannot be adjusted when Mode is set to Live or Standard.