Filter
Top Products
Setting Up the TV
28
KDX-46Q005
2-592-150-12(2)
Connecting the TV
1 Connect the display interface cable (supplied or VMC-X10 as an
optional accessary) to the DISPLAY SIGNAL IN jacks, and the AC
power cord (supplied) to the AC IN jack of the unit.
2 Secure the AC plug holder to the display’s AC IN jack.
✍ Disconnect all power sources before making any connections.
✍ Do not tighten the screws too much. It may damage the screws.
✍ Insert the connector until you hear a click. (Both sides of the connector
should be held securely by the clips.)
After connecting, make sure the connectors are firmly plugged in and
can not easily be pulled out.
✍ Refer to the optional accessory’s instruction manual for proper cable
installation.
✍ If you wish to install the media receiver unit and the display unit away
from each other, use an optional display cable, VMC-X10, which allows
you to place the two units up to 10 meters away from each other.
WHITE
DISPLAY SIGNAL IN
BLACK
AC IN
WHITE
AC IN
BLACK
DISPLAY SIGNAL IN
Display interface
cable (supplied or
VMC-X10 as an
optional accessory)
Tighten the
screw slowly
until the screw
is stabilized.
AC power cord
(supplied)