Filter
Top Products
37 (GB)
Adjusting manually
(1) Select “Dot Phase” or “Total H Pixel” with
M
/
m
or
</,
and press ENTER.
The following appears on the screen. (When
you select “Dot Phase”)
Dot Phase 3 1
(2) Adjust the dot phase or the total number of
horizontal pixels with
M
/
m
or
</,
and
press ENTER.
Note
Due to patterns in the image, there may be times when
noise continues to occur even after you have used
Auto Adjust. In such cases, adjust the dot phase
manually.
To restore Adjust Pixel menu items to their
original settings
In the Adjust Pixel menu, press
M
/
m
to move the
cursor (yellow) to “Reset” and press ENTER. Then
select “OK” with
M
/
m
and press ENTER.
Restoring the Screen Control Menu
Adjustment Values
1 In the Screen Control menu, press
M/m
to move
the cursor (yellow) to “Reset” and press ENTER.
The following menu appears on the screen.
MENU
S e l e c t E n d
S c r e e n C o n t r o l
W i d e S e t u p
W i d e M o d e :
S c r e e n Z o o m :
S c r e e n S i z e
S c r e e n S h i f t
A d j u s t P i x e l
R e s e t
4 : 3
C a n c e l
O K
ENTER
S e t
2 Press M/m to move the cursor (yellow) to “OK”
and press ENTER.
The Screen Control menu items are restored to
their original setting.
To cancel the reset function
Press MENU before pressing ENTER. Alternatively,
select “Cancel” with M/m and then press ENTER.
Resizing and Positioning the Picture
Adjusting the Pixels
If there is too much noise on the edges of characters
or vertical lines, adjust the dot phase and the total
number of horizontal pixels.
Note
This item depends on the computer signal being used.
1 In the Screen Control menu, press
M
/
m
to move
the cursor (yellow) to “Adjust Pixel” and press
ENTER.
The following menu appears on the screen.
MENU
S e l e c t E n d
A d j u s t P i x e l
A u t o A d j u s t
D o t P h a s e
T o t a l H P i x e l :
R e s e t
1 3 4 4
S e t /
ENTER
2 You can adjust the dot phase and the total number
of horizontal pixels either automatically or
manually.
Adjusting automatically
(1) Select “Auto Adjust” with
M
/
m
and press
ENTER.
The following menu appears on the screen.
MENU
S e l e c t E n d
A d j u s t P i x e l
A u t o A d j u s t
D o t P h a s e
T o t a l H P i x e l :
R e s e t
C a n c e l
O K
1 3 4 4
ENTER
S e t
(2) Select “OK” with
M
/
m
and press ENTER.
The dot phase and the total number of
horizontal pixels are adjusted automatically.