Filter
Top Products
17
Notes
•If you do not perform learning steps within
two minutes, learning mode ends.
•If you do not perform Step 4 within 10
seconds after Step 3, the display turns back to
the display in Step 2. (All the learnable keys
flash.) In this case, perform Step 3 again
while the display is flashing.
•If “NG” appears while learning, the memory
is full. To free memory, clear learned
functions from keys that you do not use often
(page 19). Then continue the learning steps.
•If you touch a key by mistake in step 4, while
pressing the LIGHT button, press the
mistaken key. Then repeat from Step 3 to
continue learning.
If the Commander does not seem to
be working
If the learned key or button does not operate
properly, teach once again. (For example, if the
volume becomes very loud after pressing the
VOLUME + button only once, noise may have
interfered during the learning procedure.)
If you set a component code after
learning a signal
If you have programmed any signal for a key
or button using the learning function, that
signal will remain assigned to that key or
button even after you set a component code.
When you teach signals to the
VOLUME or MUTING buttons
•If you have programmed any signal on
the VOLUME or MUTING button for
components other than TV and AMP
using the learning function, that signal
will be transmitted only when you
select that component.
•If you have programmed any signal on
the VOLUME or MUTING button for
TV or AMP using the learning function,
that signal will be transmitted only
when you select TV or AMP. When you
select other components, the preset
volume control signals for TV or AMP
will be transmitted (for the difference
between visual components and audio
components, see page 21). To use the
learned signal, you need to program the
VOLUME or MUTING button for each
component using the learning function.
When you teach the signals of an
air-conditioner
See the notes on page 37.
Continued