Filter
Top Products
47
2 Press the OFF key.
All the component names stop
flashing and stay lit, and “ON”
flashes.
3 Press COMMANDER OFF.
When the preset lock is on
If you try to set a component code
number (page 8) or perform learning for
the Component Select buttons (page 32),
“NG” will flash on the display.
To unlock the preset lock
To unlock the preset lock, follow the
same procedure as the above and press
the POWER ON key in Step 2. “POWER
OFF” appears on the display.
Changing the Auto
Power-Off Time of the
Commander
The Commander is preset at the factory
to switch the power off automatically
after 10 minutes if left unused (Auto
Power-Off). To change this time, perform
the following procedure.
You can set the Auto Power-Off time up
to 90 minutes, in units of 10 minutes, or
disable the Auto Power-Off function.
Note
The Auto Power-Off function only turns off the
power of the Commander, but not of the
component.
2
3
1
Continued