Filter
Top Products
26
Executing a Series of Commands
— System Control Functions
(continued)
To erase the SYSTEM CONTROL A
or C button
At the factory, the SYSTEM CONTROL A
button is preset with a series of power-off
commands for Sony components and the
SYSTEM CONTROL C button with a
series of power-on commands for Sony
components. To erase the programmed
commands for each button, follow the
steps below.
1 While pressing COMMANDER OFF,
press the MORE button.
2 While pressing the LIGHT button,
press the SYSTEM CONTROL button
(A or C).
The program for the selected button is
erased.
To set the SYSTEM CONTROL A or
C button back to the factory
setting
To reset them to the factory settings,
follow the steps below.
1 While pressing COMMANDER OFF,
press the SYSTEM CONTROL button
(A or C).
2 While pressing the LIGHT button,
press the SYSTEM CONTROL button
(A or C).
3 While pressing the LIGHT button,
press the SYSTEM CONTROL button
(A or C) again.
Note
The interval setting (page 29) is not reset to the
factory setting, even if you perform these steps.
2 While pressing the LIGHT button,
press the SYSTEM CONTROL
button (A, B or C) or the number
key (1 – 9) of which programmed
commands you want to erase.
The program for the selected button is
erased.
When you want to set a new program
to this SYSTEM CONTROL button,
follow Steps 2 to 6 on pages 23 and 24.