Filter
Top Products
29
GB
Operation
Setting remote control codes that are not
stored in the commander
When a remote control code is not one of the presets
stored in the commander, it is possible for the commander
to learn the code using the Learning function. For details
on how to use the learned codes, please see page 17.
1 Touch SETUP.
The SETUP screen appears.
2 Touch LEARNING.
3 Touch the area corresponding to where you want
the new code to be learned. Any letter from A to J
can be selected (for example, select “A”).
4 Touch the Box Number where you want to save the
new code (for example, select “A6”).
The LEARNING SETUP screen is displayed.
5 Touch “Learning Start”.
“Please Send Signal” is displayed.
6 Point the remote code receiver section of the
commander toward the receiver/transmitter on the
remote control to be learned.
7 Press the appropriate button on the remote control
to send the remote control code.
Lightly pressing the button once should be sufficient.
In about 3 to 5 seconds, it is displayed whether
learning was successful or not.
When learning is successful, “Learning OK!” is
displayed, and a mark (
■) will appear next to the
selected box.
When learning is not successful, “Learning Fail..” is
displayed, and 3 seconds later “Please Send Signal” is
displayed again. Please do this procedure again from
step 6.
To erase the learned code
After step 7, touch “Clear” and the display changes to
“Clear?”. If “Yes” is touched at this time, the newly
learned code is erased. If “No” is touched, the code is not
erased, and the commander returns to its previous
condition.
z
You can test the learned code
Touch “TEST” after “Learning OK” is displayed in step 7. The
learned code is sent from the commander, and if correct, the
operation corresponding to the learned code is performed.
z
You can make a name of up to 14 characters for the learned
code
Touch name input buttons as displayed in step 4 to enter the
name.
Learning area
Message
window
Code set mark
Box number
assigned for new
code
Command
button
Name input
button
Box number assigned for new code
About 5 cm ~ 15 cm