Filter
Top Products
30
GB
Operation
Notes
• Normally, in the areas from A to J, there is a total of 80 BOX
Numbers that can be used with the Learning function.
However, depending on the signals of the codes being learned,
it may not be possible for the commander to store codes for all
80 BOX Numbers.
• To learn commands such as volume, fast-forward, rewind (etc.)
that are generally performed by continuously pressing the
button, press and hold the button until “Learning OK” appears
in step 7. For other commands such as play, pause, and stop
(etc.) where continuously holding the button is not necessary,
learning is usually possible by pressing the button once.
• Some remote control codes cannot be learned.
Other setup
p Adjusting the position of the touch panel
(LCD)
Adjust the position of the LCD when it shifts from the
normal operating position.
1 Touch TOUCH PANEL on the SETUP screen.
The TOUCH PANEL ADJUSTMENT screen appears.
2 Touch the center of each of the 4 dots.
(For details, see “Touch panel adjustment” on page 6.)
“Adjusted” appears in a short while and long beep is
emitted.
p Setting the AUTO POWER function
ON: When a video function (DVD, etc.) is selected, the
commander sends numerous codes to the
appropriate Sony AV components. At this time, the
TV automatically switches to VIDEO 1 input mode.*
Example) When you select DVD, the following
occurs.
1 The receiver/amplifier switches to DVD player
operation mode.
2 The TV turns on.
3 The DVD player turns on.
4 The TV automatically selects VIDEO 1 input.
OFF: When a function is selected, the commander code
applies only to receiver/amplifier operation.
* Switching to VIDEO 1 input may not be automatic on all Sony
TVs. This is because some TVs cannot receive remote control
codes immediately after being turned on.
Adjusting the Commander’s Operating Environment
p Changing the function of the SYSTEM
STANDBY button
ALL OFF: Switches power of all Sony AV components
off.
ON/OFF: Switches only the receiver/amplifier on or
off.
p Setting the operation beep sound on or off
A beep can be set to sound or not sound when the touch
panel is touched.
Touch ON (sound) or OFF (no sound) in BEEP:ON
OFF in the SETUP screen.
p Setting the warning alarm on or off
A warning alarm can be set to sound or not sound when a
communication error has occurred.
Touch ON (sound) or OFF (no sound) in ALARM:ON
OFF in the SETUP screen.
p Returning settings to their factory preset
settings
Use this function to erase all memorized settings and
return them to their factory presets.
Please note that once erased, settings cannot be returned.
When carrying out this operation, make sure that the receiver/
amplifier’s power is on, and be sure to point the commander’s
transmitter/receiver section toward the display on the receiver/
amplifier.
1 Touch ALL CLEAR on the SETUP screen.
2 Touch YES.
p CONTROL A1 auto function (AUTO FUNC)
ON: When a component connected via a CONROL A1
cord is played, the power to this unit is turned on
and the function selector is automatically set for that
component.
OFF: When you do not want linked control of
connected components, select [OFF].
When AUTO FUNC does not appear in the display,
use the JOG DIAL to scroll the screen until AUTO
FUNC appears.