Filter
Top Products
28
Notes on learning the
signals of an air-
conditioner
About seasonal adjustments
If you change the settings of the
air-conditioner for the season, you
have to programme the remote
control signals of the new settings
on the Commander.
If the power-on/off operation
does not work correctly
The air-conditioner may not be
turned on or off properly with the
button or key of this Commander,
for which you have programmed
its power-on/off signal.
If the Commander can operate
only “ON” with one button or
label and “OFF” with another,
while your air-conditioner’s
remote control can operate “ON/
OFF” with a single button or label,
programme the signal on two
buttons or labels of the
Commander as follows.
1 Clear the learned power-on/off
signal from the button or label
(page 29).
2 Programme the signal
(transmitted from the power-
on/off button of the air-
conditioner’s remote control)
for the button or label again.
3 Programme the signal from the
same button of the remote
control for another button or
label.
The two buttons or labels of the
Commander have been
programmed with the power-on
signal and the power-off signal of
the air-conditioner, respectively so
that you can operate the air-
conditioner with the Commander.
If you make a mistake, move
the cursor to the digit or
character you want to correct
by pressing the or button,
and input again.
4 Decide the digit or the
character you input by
pressing the Joystick
toward
.
The cursor moves to the right.
When the Joystick is pressed
toward , the cursor moves to
the left. You can input a digit or
character to the place where
the cursor flashes.
5 Repeat Steps 3 and 4 until
you input a suitable name
to the label.
When the cursor reaches to the
right end, if the Joystick is
pressed toward , the cursor
returns back to the left end.
6 Press the SET button.
The commander enters the
learning standby mode.
Using Non-Preset Remote
Control Operations
— Learning Function (continued)