Filter
Top Products
8
Setting up the remote commander
Getting Started
Step 2 : Setting up the remote commander (continued)
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your TV is
listed in the table below, set the appropriate manufacturer’s code number.
*
These buttons may not work with all TVs.
Tip
• When you set your TV’s code number correctly while the TV is turned on, the TV turns off
automatically.
1
Set TV/VIDEO at the top of the remote commander to TV.
2
Hold down / , and enter your TV’s code number(s) using the programme
number buttons.Then release / .
Now you can use the following TV control buttons to control your TV:
/ , TV/VIDEO, programme number buttons, –/– – (ten’s digit), PROG +/–,
+/–, (TV), (Teletext), FASTEXT buttons, WIDE
*
, MENU
*
, CURSOR
*
/
*
/
*
/
*
, and OK
*
.