Filter
Top Products
SmartFile function
99
Protecting a recorded programme
To unlock the protected programme
Press
CURSOR
in the step 4 above. The indicator disappears and you can record
over this programme.
Tips
• When you start recording from a position prior to the protected programme, the recording
automatically stops no more than about four minutes in SP mode and about eight minutes in
LP mode before the beginning of the protected programme. The BLANK TIME indicator
flashes in the display window.
• If you protect a programme just after the Blank Time space, BLANK TIME becomes
shortened by about four minutes in SP mode and about eight minutes in LP mode.
• If you try to record on a SmartFile tape containing a protected programme, a message
indicating that there is a protected programme on this tape appears on the TV screen.
Notes
• When you record another programme just after a protected programme, locate the beginning
of the Blank Time space by following the instructions in “Recording after locating the Blank
Time space” on page 83. Otherwise, if the recording start point overlaps the protected
programme, the VCR may over-record the protected programme.
• If you insert a SmartFile tape which contains a protected programme or protect a programme
for the first time on a new tape, the VCR will analyse the position of the protected
programme for a few seconds. You cannot operate the VCR while the VCR is analysing the
tape.
• If the SmartFile list contains 12 protected programmes, the next programme you record won’t
be stored in the SmartFile list.
• When you try to turn off the VCR after setting a ShowView timer recording on the protected
programme, the VCR automatically ejects the cassette.
• The protecting function may not work with an NTSC-recorded tape.