Filter
Top Products
76
Additional Information
Troubleshooting
If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your nearest
Sony dealer.
The power is not turned on.
,
Check that the AC power cord is connected
securely.
There is no picture.
,
The connecting cords are not connected
securely.
, The connecting cords are damaged.
,
The player is not connected to the correct TV
input jack (page 18).
,
The video input on the TV is not correctly set.
Picture noise appears.
,
The disc is dirty or flawed.
,
If the picture output from your player goes
through your VCR to get to your TV, the copy-
protection signal applied to some DVD
programs could affect picture quality. If you
still experience problems even when you
connect your player directly to your TV,
please try connecting your player to your TV’s
S video input (page 18).
,
You have selected “PROGRESSIVE” in
“COMPONENT OUT” even though your TV
cannot accept the signal in progressive format.
In this case, set the VIDEO OUT SCAN
SELECT switch on the back panel of the
player to INTERLACE. Then set
“COMPONENT OUT” to “INTERLACE”
after you can see the TV screen correctly and
reset VIDEO OUT SCAN SELECT to
SELECTABLE.
, Even if your TV is compatible with
progressive format (480p) signals, the image
may be affected when you set
“COMPONENT OUT” to “PROGRESSIVE.”
In this case, set “COMPONENT OUT” to
“INTERLACE.”
Even though you set the aspect ratio
in “TV TYPE” of “SCREEN SETUP,”
the picture does not fill the screen.
, The aspect ratio of the disc is fixed on your
DVD.
There is no sound.
, The connecting cord is not connected securely.
,
The connecting cord is damaged.
, The player is connected to the wrong input
jack on the amplifier (receiver) (page 22, 23,
24).
, The amplifier (receiver) input is not correctly
set to the player.
, The player is in pause mode or in Slow-motion
play mode.
,
The player is in fast forward or fast reverse
mode.
,
If the audio signal does not come through the
DIGITAL OUT (OPTICAL or COAXIAL)
jacks, check the audio settings (page 75).
Sound is noisy.
,
The disc is dirty or flawed.
,
When playing a CD with DTS sound tracks,
noise will come from the LINE OUT L/R
(AUDIO) 1/2 jacks (page 30).
Sound distortion occurs.
,
Set “AUDIO ATT” in “AUDIO SETUP” to
“ON” (page 74).
Power
Picture
Sound