Filter
Top Products
77
Other Information
Other Information
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the LCD projection TV’s remote control, use the following procedures
to program the remote control.
From the “Manufacturer’s Codes” listed on page 79, select the three-digit
code number for the manufacturer’s code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1
11
1
Open the panel of the remote control.
2
22
2
Press
CODE SET
inside the panel.
3
33
3
Close the panel and press
SAT/CABLE (FUNCTON)
.
4
44
4
Enter the three-digit manufacturer’s code number using the
0-9
buttons.
5
55
5
Press
ENTER
.
6
66
6
To check if the code number works, aim the LCD projection TV’s
remote control at the component and press the green POWER
button
that corresponds with that component. If it responds, the programming
is completed. If not, try using the other codes listed for that
manufacturer.
Sony
Equipment
Switch Position
on Remote Control
Programmable
Code Number
Beta, ED Beta VCRs AV1 303
8 mm VCR AV2 302
VHS VCR AV3 301
DVD Player DVD 751
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
(Continued)