Filter
Top Products
7/50D Plus or 7/50D Controller Chapter 3: Installation 35
3-5 Setup
This section provides the procedures for configuring your 7/50D Plus or 7/50D
controller. Configuration of your controller includes setting the number of stations and
pumps, setting variables such as convey time and blow-back interval, and setting up
passwords. We recommend that you carry out these procedures in the order given here.
Note: Before carrying out these procedures, install all equipment as
described in this section and in the Mechanical Components manual.
Figure 18 below gives an overview of the basic flow between the menus used in setting
up the system.
Figure 18: Basic Menu Flow for Setup
Station
Summary
Pump
Summary
Station n
Operator
Pump n
Setup
Station n
Setup
System
Setup
DeviceNet
Node Status
DeviceNet
Input Status
hold icon hold icon
Setup
System
System
System
Pumps
Stations