Filter
Top Products
10-Pump, 80-Station Controller Chapter 8: Appendix 87
5. Go to the System Setup Screen (Fig 6) by pressing the System Setup button on any screen.
Fig 6
6. Go to the Save / Restore Screen (Fig 7) by pressing the Save / Restore button on the right side of
the screen.
Fig 7
7. Save Settings by pressing the yellow Save Settings button.
8. Wait for the “Save Complete” message. (This message is only displayed for 10 seconds).
9. Turn off power to the control enclosure. Wait 5 seconds. Turn on power.
10. Wait for the Run LED on the top front of the CPU to turn solid green and for the I/O LED to
stop blinking (Fig 8) for 30 seconds. If a firmware upgrade is not required, this will only take