Filter
Top Products
10-Pump, 80-Station Controller Chapter 8: Appendix 89
VersaView CE 1000H Setup
Use this procedure to setup a new VersaView display or to upgrade a VersaView display for use on a
Sterling 10 Pump – 80 Station Convey Control.
1. Remove the compact flash card from the VersaView if one is installed by pressing the Eject
Button (Fig 9).
Fig 9
2. If you are setting up a Remote
Display, disconnect the Ethernet cable connecting the VersaView
to the network. If you are setting up the Primary
Display, leave the Ethernet cable connected.
3. Cycle power on the VersaView.