Filter
Top Products
Troubleshooting Tables
37
Problem Solution
You cannot operate
a device even after
using the Learning
Function.
1. Make sure that your SRC 3000 has
correctly learned the target
device’s remote control code
(page 15).
2. Delete the device data from the
SRC-3000b and carry out the
learning function again (page 15).
3. Make sure you did not program
more than one remote for a given
device.
You see “ERROR”
display on the LCD
during the learning
procedure.
1. Make sure you hold the target
remote’s key till the screen
displays Ok or Error on the screen.
2. Make sure the two remotes are
not too close or too far apart -
keep them about 2~4 inches
(5~10 cm) apart, and your device
remote control is aiming directly at
the SRC-3000b’s learning eye.
Your VCR will not
record.
1. As a safety feature on the SRC-
3000b, you must press the REC key
for two seconds.
Macro does not
work.
1. Be sure to aim the SRC-3000b at
the devices while the Macro
commands are being sent.
2. Macro was not properly set up.
Repeat Macro set-up procedure
(page 22).