Filter
Top Products
Chapter 1: Introduction
1-3
Onboard Controllers/Ports
An onboard IDE controller supports Ultra ATA 100 hard drives or ATAPI devices.
Onboard I/O backpanel ports include one COM port, a VGA port, two USB ports, two
Gigabit LAN (NIC) ports and (on the 6015T-INF only) an Infi niBand® port. There
are two sets of I/O ports included in the server (one set for each severboard).
Infi niBand Port Bracket: The Infi niBand port bracket is a small "U" shaped
bracket that secures the connector to the I/O port shield. This allows the
I/O shield, not the serverboard, to support the cable's weight. The bracket
can be found on the connector itself.
When installing the serverboard, remove the bracket from the Infi niBand
port. Slide the port through the shield, and then replace the bracket to se-
cure the port to the I/O shield.
ATI Graphics Controller
The X7DBT-T/X7DBT-INF features an integrated ATI video controller based on the
ES1000 graphics chip. The ES1000 was designed specifi cally for servers, featuring
low power consumption, high reliability and superior longevity.
Other Features
Other onboard features that promote system health include voltage monitors, a
chassis intrusion header, auto-switching voltage regulators, chassis and CPU
overheat sensors, virus protection and BIOS rescue.
!