Filter
Top Products
Chapter 5: Advanced Serverboard Setup
5-3
5-3 Connecting Cables
Now that the serverboards are installed, the next step is to connect the cables to
the boards. These include the data cables for the peripherals and control panel
and the power cables.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed to prevent them from blocking the fl ow of cooling air that moves through
the system from front to back. If you need to disconnect any of these cables, you
should take care to keep them routed as they were originally after reconnecting
them (make sure the red wires connect to the pin 1 locations). The following data
cables (with their locations noted) should be connected. (See the layout on page
5-9 for connector locations.) Note that each connection listed should be made for
both serverboards in the chassis.
SATA drive cables (SATA1)
Control Panel cable (JF1)
Connecting Power Cables
The X7DBT-T/X7DBT-INF has two 20-pin ATX power supply connectors for con-
nection to the ATX power supply. Only one of these from each board should be
connected to the power supply. The "Primary ATX Power Header" is used to supply
power to the primary serverboard and the "Secondary ATX Power Header" is used
to supply power to the secondary serverboard. Connect the power supply to only
one of these on both boards (primary = left, secondary = right when viewed from
front of server). See Section 5-9 for power connector pin defi nitions.