Symphonic SC1304 TV VCR Combo User Manual


 
EN - 10 -
USING FRONT A/V INPUT JACKS
When you watch a program recorded on another source (VCR or video camera), use the
AUDIO/VIDEO input jacks on the front of the unit.
Connect the Audio/Video output jacks of another source to the AUDIO and VIDEO jacks
of this unit.
Then use [CHANNEL
KK
/
LL
] until “AUX” appears on the screen.
VIDEO AUDIO POWER VOLUME CHANNEL STOP/EJECT REW PLAY F.FWD REC/OTR EARPHONE
VIDEO AUDIO
ex.
VCR or video camera
, etc.
[Front of the unit]
To the Audio output jack
To the Video output jack
AUX
(OUT)
(IN)
(OUT)
(IN)
TV OPERATION AND SETTINGS
WATCHING A TV PROGRAM
1 Plug in the power cord
After antenna or cable connection is com-
pleted, connect the power cord into a stan-
dard AC outlet.
NOTE:
If any digits appear in the corner of the
screen, press [POWER] without unplug-
ging the power cord.
2 Turn on the unit
Press [POWER] to turn on the unit.
3 Select the channel number
Use [CHANNEL
KK
/
LL
] or the Number buttons to
select your desired channel number.
Note for using the Number buttons:
¡You must precede single-digit channel numbers
with a zero (for example: 02, 03, 04 and so on).
¡When selecting cable channels which are higher
than 99, press [+100] first, then enter the last two
digits. (Example: to select channel 125, first press
[+100] then press [2] and [5].)
4 Adjust sound
Use [VOLUME
XX
/
YY
] to adjust the
volume.
Press
[MUTE] to instantly mute
the sound.
Press it again to restore the previous sound level.
TO WATCH CABLE OR SATELLITE
CHANNEL
If the unit is connected to a cable box or satellite
box, use [CHANNEL
KK
/
LL
] to select CH3 or CH4
according to the output channel setting of the
device and select desired channel on that device.
TO WATCH EXTERNAL INPUT
When an external equipment is connected to the
front AUDIO/VIDEO input jacks, use
[CHANNEL
KK
/
LL
] repeatedly until “AUX”
appears on the screen.
VOLUME 20
C C C C C C C C C C C C
Audio cable
(commercially available)
Video cable (commercially available)