Filter
Top Products
EN - 8 -
INSTALLING THE BATTERIES
1)
Open the battery compartment cover by pressing the
cover on the remote unit in the direction of the arrow.
2)Insert 2 “AA” penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3)Replace the cover.
[BATTERY PRECAUTIONS]
•
Be sure to follow the correct polarity as indicated
in the battery compartment. Reversed batteries
may cause damage to the device.
•
Do not mix different types of batteries together
(e.g. Alkaline and Carbon-Zinc) or old batteries
with fresh ones.
•
If the device is not to be used for a long period of
time, remove the batteries to prevent damage or
21 RECORD button– Press to start manual recording.
22 SPEED button– Press to choose the desired
recording speed:SP/SLP.
23 T- PROG. CLEAR button– Press to cancel a set-
ting of timer program. (Refer to page 24.)
COUNTER RESET button– Press to reset counter
to 0:00:00.
24 GAME button–
Press to set the Game mode and exter-
nal input mode at the same time. (Refer to page 15.)
25 WAKE-UP/SLEEP button– Sets the Wake up or
Sleep Timer. (Refer to page 14.)
26 EJECT A button– Press in the stop mode to
remove the cassette from the unit.
27 CHANNEL RETURN button– Press to go back to
the previously viewed channel. Press again to
return to the present channel.
28 CHANNEL
K
/
L
buttons– Use to select the
desired channels for viewing or recording.
TRACKING function– Use to minimize video
‘noise’ (lines or dots on screen) during playback
mode. (Refer to page 18.)
ANT.
3635
- REAR VIEW -
35 Power cord– Connect to a standard AC outlet
(120V/60Hz). (Refer to page 10.)
36 ANT(ENNA). jack– Connect to an antenna, cable
system or satellite system. (Refer to page 9.)
29 VOLUME
XX
/
YY
buttons– Adjust the volume
level.
30 MUTE button– Press to mute the sound. Press it
again to restore the sound.
31 PLAY /
K
(cursor) button–
•
Press to start playback.
•
Press to select a mode or figure from the
setting menu.
32 F.FWD /
BB
(cursor) button–
•
Press to rapidly advance the tape or to view the
picture rapidly in forward during playback
mode. (Forward Search)
•
Press to determine your selection and proceed
to the next step in the setting menu.
33 PAUSE/STILL F button– Press to temporarily
stop the tape during the recording or to view a
still picture during playback.
34 TIME SEARCH button– Press to activate Time
Search mode.
injury from possible battery leakage.
•
Do not try to recharge batteries not intended to be
recharged; they can overheat and rupture.
IR SIGNAL CHECK
Use the AM radio or the digital camera to check if the
remote control properly sends out the infrared signal.
It will help to define the cause of malfunction.
Using AM radio
•
Tune the AM radio to no broadcasting
station. Press any button on remote
control toward the radio. If the radio
receives the signal from remote control
properly, the sound will flutter.
Using digital camera
(including built-in camera of
cellular phone)
•
Press and hold any button on remote
control toward a digital camera. The
remote control is working if you confirm
infrared light through the digital camera.