Filter
Top Products
programming the system remote
|
49
To erase all learnt commands for one device:
1. Press the REMOTE SELECTION key for the appropriate device and the ok key
simultaneously until the status LED turns yellow and chosen REMOTE SELECTION key is lit.
2. Press and hold the light key. The status LED will flash red five times and the selected
devices LED will turn off. Release the light key; the status LED will flash green twice then
turn a steady yellow and the selected device key LED will turn on again.
3. To finish, press and hold the REMOTE SELECTION and ok keys simultaneously. The
REMOTE SELECTION key LED will go out and the status LED will flash yellow twice then
go out.
erasing all commands for one device
48
|
programming the system remote
erasing all commands for all devices
To erase all learnt commands for ALL devices:
1. Press and hold the tv REMOTE SELECTION and light keys simultaneously. The status LED
will flash red 10 times, then green once, yellow once and turn off
(1)
.
remote control warning
You will, from time to time, have to replace the batteries in your system-remote. During the
battery changing operation the Remote will remember your programmed commands, but you
should avoid pressing any key on the Remote during battery changing as you may lose all
your stored settings.
1. Caution – this will erase every function that you have programmed into the Remote
erasing single commands
To erase a learnt command from a key:
1. Simultaneously press the REMOTE SELECTION key for the appropriate
device and the ok key until the status LED turns yellow and the chosen
REMOTE SELECTION key is lit.
2. Press the key for the function which you wish to erase. The REMOTE
SELECTION LED will turn off and the status LED will flash continuously
yellow.
3. Press the light key. The status LED will flash green twice then turn a constant
yellow colour. The chosen REMOTE SELECTION key LED will turn back on.
Repeat steps 2 and 3 to erase any other learnt commands for the selected
device.
4. To finish, simultaneously press and hold the REMOTE SELECTION and ok
keys. The REMOTE SELECTION key LED will go out and the status LED will
flash yellow twice then go out.
erasing a macro function
To erase a macro function:
1. Simultaneously press the appropriate REMOTE SELECTION key (av
or sat) and the mute key until the learning status LED turns red.
2. Press the macro key (m1 to m4 or standby) you wish to erase.
3. Press the CH + (or CH -) key. The learning status LED will flash red
twice then go off.
cd dvd amp
av
REMOTE SELECTION
sat
tv vcr ld
pause
play
skip
+
record
skip
eject
---
stop
ok
return
cancel
LFE
LFE
---
+
r
e
w
f
f
d
--- ---
light
GRR00868.01-DVD32RFLR UM 5/30/02 12:26 PM Page 48