2.3 TV + VCR + DVD CONNECTION
YY
75OHM
ANTENNA
INPUT
CC
b b
CC
r r
AV
OUTPUT
YUV
INPUT
AV
INPUT2
VIDEO
AUDIO-L
AUDIO-R
AUDIO-L(MONO)
AUDIO-R
VIDEO
AUDIO-L
AUDIO-R
Connect the audio cables (white and red) to the R and L AUDIO jacks on the TV and the Audio output
jacks on the VCR (or other component). Match the cable color to the jack color.
If your component has Component Output jacks YUV (Y, Cr, Cb), connect three video grade cables to
the Y, Cr, Cb jacks on the component and to the Y, Cr, Cb jacks on the TV. If your component does not
have these jacks, go to the next step.
If your component has an S-VIDEO jack, connect an S-VIDEO cable to the S-VIDEO jack on the front
of the TV and to the S-VIDEO jack on the component. If your component does not have an S-VIDEO
jack, go to the next step.
Connect a video cable (yellow) to the VIDEO INPUT jack on the TV and to the VIDEO OUT jack on your
VCR (or other component).
Turn on the TV and the component.
Press the TV/AV button repeatedly until the correct video input channel appears in the upper right corner
of the TV screen. For front inputs choose AV1, for rear AV inputs choose AV2 . This model has component
jacks (Y, Cb, Cr), choose YUV as your video input channel.
Note:
Use either S-VIDEO jack or VIDEO INPUT1 jacks. Do not use both at the same time for the same piece
of equipment. This would interfere with the picture display.
The basic component (VCR, DVD player etc.) to TV connection is described below. For other hookup,
refer to your component s instruction manual.
Rear panel
Front AV input
(AV1 INPUT)
Under the status of DTV, repeatedly press TV/AV button to switch between DTV, AV1,AV2, DVD,
SVHS mode, please see the following:
AV1 AV2 DVD SVHS DTV.
Under the status of ATV, repeatedly press TV/AV button to switch between TV, AV1,AV2, DVD,
SVHS mode, please see the following:
AV1 AV2 DVD SVHS TV.
VIDEO
AV INPUT1
S-VIDEO
AUDIO
L(MONO)R
11