Filter
Top Products
Caution:
To avoid damaging the speakers with a sudden
high-level signal, be sure to switch the power off
before connecting the speakers.
Check the impedance of your speakers. Connect
speaker with an impedance of 4 ohms or more.
The black speaker terminals are – (negative).
Generally, the + side of the speaker cable is marked
to make it distinguishable from the – side of the
cable. Connect this marked side to the + terminal
and the unmarked side to the black – terminal.
Prepare the speaker cables for connection by
stripping off approximately 10 mm or less of the
outer insulation. (Removing too much insulation
may lead to a short circuit if the bared wired should
come in contact with each other.) Twist the strands
of the stripped wires tightly together:
Caution:
The metal portions of the two separate wires
should not touch or an electrical short can occur.
Shorted wires can create a fire hazard or induce a
failure in your equipment.
How to connect speakers:
1. Turn the terminal cap counterclockwise to loosen it.
The speaker terminal caps cannot be fully removed
from the base.
2. Insert the wire into the terminal fully and turn the
terminal cap clockwise to securely connect it:
Make sure none of the wire insulation is under the
terminal, only the bare, stripped wire.
3. Make sure it is fastened firmly by pulling the cable
lightly.
Subwoofer
Connect a subwoofer using a commercially-
available RCA cable.
Use a subwoofer with built-in amplifier referred to
as a ‘powered subwoofer’.
11