11
Installing batteries in the remote
control
1. Remove the battery compartment cover at
the rear of the remote control by
depressing the retaining clip.
2. Install two AAA batteries as shown,
ensuring the polarity matches that shown
in the battery compartment.
3. Replace the battery compartment cover.
Using the remote control
To use the remote control, point it at the box
and press the required buttons.
You must be within 6 metres and at an angle
of less than 30 degrees from the centre of
the box.
WARNING! DO NOT LEAVE
BATTERIES IN THE REMOTE
CONTROL FOR EXTENDED
PERIODS AS THEY CAN LEAK
OR C O RR O D E C A U SI N G
DAMAGE TO THE REMOTE
CONTROL. CHECK THEM
PERIODICALLY AND REPLACE
THEM AS REQUIRED.
WARNING! DO NOT MIX
BATTERY TYPES. WHEN
INSERTING BATTERIES,
REPLACE ALL BATTERIES AT
THE SAME TIME. DO NOT MIX
OLD AND NEW BATTERIES.
W AR N I N G ! E X HA U S T E D
BATTERIES MUST BE TREATED
WITH CARE AND DISPOSED OF
ACCORDING TO ANY SAFETY
OR RECYCLING REGULATIONS
IN FORCE IN YOUR LOCAL
AREA. NEVER DISPOSE OF
BATTERIES INTO GENERAL
WASTE, OR FIRE.
Remote control
Note: Sunshine or other strong
light sources may interfere
with the signal from the remote
control. In this situation turn the
box away from the light source.