Technika STBHDIS2010 DVR User Manual


 
14
Note: You can re-tune your box
again at any time. See Channel
tune on page 22~23.
Operating the box
3. Press OK to begin the automatic tune
4. The box searches for and displays all
the available TV and radio channels
5. Once the automatic search has been
completed, you will be prompted to
select ‘Yes’ to see the list of channels or
‘No’ to start watching TV.
Basic operating instructions
Switching on for the rst time
You need to perform automatic channel
tuning when you turn the box on for the rst
time
To perform automatic tuning:
1. Make sure your box is connected to the
mains and that it is connected to the aerial
2. Press
to turn the box on. After a short
time, a welcome menu appears 2. Press
the OK button to enter the tuning menu.
Standby
Press to put the box into standby,
Channel Zero’s services and content are
loaded in standby. See Channel Zero on page
29.
The box automatically goes into standby after
3 hours if you do not use the remote control.
You can adjust this time by changing the TV
settings. See TV on page 25.
Note: You can make the box in
passive standby pressing
for 3
seconds.
However, this will cause Channel
Zero’s content to be lost and the
box will have to be re-loaded
according to the basic operating
instructions – see Accessing
Channel Zero services on page
29.
Source selection
Press the TV / R button to switch between TV
and radio channels.