Filter
Top Products
12
WARNING! ENSURE THE
TV AND ALL ANCILLARY
EQUIPMEN ARE UNPLUGGED
FROM THE MAINS BEFORE
MAKING ANY CONNECTIONS!
Connecting the TV aerial
Connect the TV aerial to the ‘RF IN’ socket
on the rear of the box with a 75 ohm co-axial
plug. For best results use a high gain TV
aerial, preferably roof or loft mounted.
Use a professionally installed external, roof
mounted aerial wherever possible.
To improve the picture quality in a poor
signal area, purchase and install a signal
amplier.
Connecting the box
RF IN RF OUT
Connecting to the TV and other
devices
The Quick Start Guide shows the simplest
and most effective way to connect the box to
ancillary equipment. Alternate methods are
listed below.
Coaxial cable
If your TV does not have a SCART socket,
you can connect the box to the TV using
a coaxial cable. Connect the coaxial cable
between the ‘RF OUT’ socket on the rear of
the box and the aerial socket on your TV.
Using this connection method will also allow
your TV to receive a signal when the box is
switched off.
SCART cable
You can connect the box to your TV and VCR
using a SCART cable. This connection uses
component video signals, i.e. the red, green
and blue (RGB) content of the video are sent
on separate signals.
To connect the box to your TV, connect the
SCART cable between the ‘TV’ SCART socket
on the rear of the box and the SCART socket
on your TV.