Filter
Top Products
The following adjustments can be made in this sub-menu:
5.4.1 Switch DiSEqC on or off
DiSEqC (Digital Satellite Equipment Control) is a digital control signal used to control and
switch DiSEqC-compatible components via the antenna cable.
If your external unit is equipped with DiSEqC components, you must switch on the DiSEqC-
control:
> Make adjustments in this line by means of the key OK DiSEqC on or off.
Since only one LNB can be addressed when the DiSEqC control is switched off, the
menu is restricted to the configuration of a single LNB.
5.4.2 Setting the switching matrix and the LNB properties
The menu lists the four switching criteria of the DiSEqC control.
Your receiver has been pre-programmed, so that ASTRA will be received in switch position
A/A and Eutelsat in switch position B/A of a multiswitch. If the switching matrix of your recep-
tion equipment be configured differently, or if it is set to receive other satellites, you can
make the following settings/adjustments in your receiver.
> Use the arrow up/down keys dto select the DiSEqC switch position (1-4) that you
want to allocate to a particular satellite (e.g. A/B 3 No Satellite), by marking this
line in blue.
> Confirm by pressing OK.
A list of various satellites will now be displayed.
> Use the arrow up/down keys to mark the satellite selected.
The arrow up/down keys will move the marker up or down one line at a time,
while using the Parrow left/right keys will jump to the previous or next page.
If the satellite you are looking for is not specifically listed, select one of the spare posi-
tions, marked as User1 to User 14.
> Confirm by pressing OK.
The selected and marked satellite will now be inserted and shown at the previously
marked position in the menu >Settings>LNB.
Continue to work your way through the Menu >Settings>LNB, until the data in this menu
corresponds with that of your reception unit. Any switching criteria not required should be set
to the position No Satellite.
5.4.3 Additional settings
Now that you have adjusted the switching matrix of your DVB receiver to correspond with
your reception unit, you should now check the additional parameters of your reception unit,
and, where necessary, make further corrections.
> Use the arrow left/right keys to move the marker to the column LNB-Test.
> Now use the arrow up/down keys, to mark the field Continue.in the line in
which you want to check or alter the settings.
> Confirm by pressing OK.
The menu >LNB>Check will now be displayed, showing the DiSEqC setting selec-
ted (e.g. A/A 1).
14
DIGIBOX1_englisch.qxd 26.09.01 09:55 Seite 14